Trixie 24383, Инструкция по эксплуатации

Страница: 4 / 28

4
E
Instructions
Please read the instructions fully before you start opera-
ting the device.
Installing batteries:
1. Unlock the cover with the release knob and lift it off. The
battery compartment is on the underside of the cover.
2. Remove the battery covers and install four new Alkaline
batteries Baby C.
3. Replace the battery covers. Make sure that the covers
snaps securely into place.
4. Place the device securely on even ground.
Turning the device on:
1. Open the cover of the control panel and switch the device
on or off with the ON/OFF button (the round button on
the left).
2. When the device is switched on, the time will automati-
cally flash at ‘12:00 A.M.’.
3. Every time a button is pressed, the automatic food dis-
penser confirms this with a beep. First press the ENTER
button to set the current time. The hour flashes.
4. Use the arrow buttons to set the hour. During setting, the
time changes automatically between A.M. (morning to
noon) and P.M. (afternoon to midnight).
5. After you press ENTER again, the minutes start flashing.
6. Use the arrow buttons to set the minutes.
7. When the time is correct, end the setting process by pres-
sing ENTER.
Choosing the meal:
1. Keep ENTER pressed for 3 seconds. Now MEALS begins to
flash, and you are in the meal setting mode. Press ENTER
again and BREAKFAST flashes.
2. Use the arrow buttons to choose the meal that you want
to programme. BREAKFAST, LUNCH and DINNER will
flash one after the other when the arrow buttons are
pressed.
3. Press ENTER when you have chosen the meal you want.
a. Then YES will flash. Now press ENTER if you want to set
the time for the meal.
b. If you do not want to set the time for this meal, use the
downward arrow to choose NO and then press ENTER.
Please note: If NO is chosen, the software will go back to
MEALS. Use the arrow buttons to choose the meal that
you want to programme.
Feeding times:
After you have chosen the MEAL and selected YES, the
hour flashes.
1. Use the arrow buttons to set the hour for the meal.
2. Please note: during setting, the time changes automati-
cally between A.M. and P.M.
3. Press ENTER again and the minutes start to flash.
4. Use the arrow buttons to set the minutes for the meal.
5. Press ENTER when the minutes have been set. The menu
then automatically continues to setting the meal size
(BOX).
Setting meal size:
After you have set the feeding time, the menu for setting
the meal size flashes (on the right on the display).
1. Set the meal size that is to be served with the arrow
buttons. For each meal, you can choose 1, 2 or 3 feed
chambers. One food unit is one of the six feed chambers in
the device (240 ml). If you choose two or three food units
for a meal, the next chamber will open one after the other
with an interval of 10 minutes.
2. Press ENTER to end the setting.
Setting further meals:
Repeat the programming as described above for each
meal. After you have programmed all meals, keep pres-
sing ENTER until the device beeps twice. That means your
settings are confirmed.
Important:
• The counter SERVED shows how many food units have
been served. Once all 6 food units have been served, the
red LED light flashes slowly and new food has to be filled
in. After filling the device, press START and the device will
work according to the programming. The counter goes
back to zero.
• After programming, make sure that the cover over the
control panel is securely fastened so that your pet cannot
change the settings by accident.
Extra option manual feeding : Keep the down arrow
pressed for 3 seconds. This releases one food cavity imme-
diately.
Information:
• The following feeding times are preset: breakfast at 6:00
A.M., lunch at 12:00 P.M. and dinner at 6:00 P.M.
• The programming has to be completed within 10 minutes.
If this is not the case, the red LED light continues to flash
to remind you that the setting has not been completed.
If you do not attempt a new setting, the device will work
according to the existing settings. If you have not set
any meal, the device works according to the preset times
(6:00 A.M., 12:00 P.M., 6:00 P.M.). This ensures that your
pet is not left hungry with no food at all.
• If the meal size is 240 ml or less, one chamber is enough
to serve the desired meal. If the meal size is more than
240 ml, e.g. 360 ml, you need 2 chambers, one full and
one half full.
• If the meal size is more than one chamber, there is a wai-
ting time of 10 minutes before the next chamber opens.
Changing the programming:
• If you want to change the programming later, keep ENTER
pressed for 3 seconds. MEALS flashes and you are in
setting mode. Press ENTER again and you can change the