13
Possible Selectrix Settings
• Programming Possibilities:
– Locomotive Addresses
00 ... 99 (03)
– Maximum Speed
1 ... 7 (5)
– Acceleration / Braking Delay (AFB) 1 ... 7 (4)
– Pulse Width (Duration)
1 ... 4 (2)
– Signal Braking Block
1/2 part (1)
• Additional Settings:
– Swapping Connections
0 ... 7 (4)
– AFB Effectiveness
1 ... 2 (1)
– Variations in Motor Control
1 ... 4 (3)
( ) = Setting done at the factory
Information about Selectrix Operation:
If a locomotive enters a braking block that is
on against the direction of travel for that block,
the headlight(s) for that locomotive may go out
depending on how that locomotive is wired. The
headlight(s) will come back on after leaving the
braking block.
Selectrix Operation
Place the locomotive on the programming track
and read out the settings for the decoder. The
basic setting should be 03-542. Temporarily run
the locomotive with these settings and check out
the functions available on the locomotive. After
you have completed this first testing period, you
can adapt the parameters for the locomotive to
your needs.
If the reader unit shows “Lesefehler” (“Reader Er-
ror”), check again to make sure that the locomo-
tive is properly wired and reread the instructions
for making connections to the programming
track. In this situation
do not
under any circum-
stances start running the locomotive on your
layout!
Содержание 66839
Страница 1: ...66839...