INSTALLATION
1. Separate the dome cover from the camera base. Use camera base as a tem-
plate to mark the mounting holes.
2. Drill holes on the ceiling /wall and cut a Ø 1” hole for the cable to pass
through.
3. Mount the camera base to the ceiling / wall.
4. Connect the service monitor to the service port. Aim the camera to the desire
angle by adjusting the Pan / Tilt / Zoom / Focus.
5. Attached the dome cover to dome base.
SPECIFICATION
Image Sensor
1/3” Sony Super HAD II CCD
Total Pixel
811 (H) x 508 (V)
Horizontal Resolution
540 TVL
Sensitivity
0 Lux when IR is ON
Lens
2.8-10mm / F1.2
S/N Ratio
more than 50 dB
Horizontal Frequency
15.734 KHz
Vertical Frequency
59.94 Hz
Power
12VDC / 24VAC
Power Consumption
~3W (250mA)
IR OFF
~8W (670mA)
IR ON
Synchronization
Internal
IR Illuminator
Thirty (30) 850nm LED
IR LED off > 5 lux, IR LED on < 2 lux
Illuminated Distance
100 ft
Mechanical IR Cut Filter
Color Mode > 5 lux, B/W Mode < 2 lux
Electronic Shutter
ON ( 1/60 sec ~ 1/100,000 sec) / OFF ( 1/60 sec)
Backlight Compensation
ON / OFF
Automatic Gain Control
ON / OFF
White Balance
Automatic
Noise Reduction (DNR)
Automatic
Operating Temperature
-10ºC to +50ºC
Operating Humidity
Maximum 80% RH
Housing
Aluminum Alloy
Dimensions (Dia x H)
5.51” x 4.41” (140 x 112 mm)
Weight
2.09lb
Safety Compliance
FCC, CE
Note: Design and specifications are subject to change without notice.
