Triumph Thunderbird Commander, Руководство пользователя

Страница: 83 / 136

83
Maintenance and Adjustment
Coolant Level Adjustment
Allow the engine to cool.
1. Final drive belt cover
2. Final drive belt cover screws
Remove the final drive belt cover as follows:
Release the four screws from the cover and
remove.
Remove the cap from the expansion tank,
and add coolant mixture through the filler
opening until the level reaches the MAX
mark. Refit the cap.
Note:
• If the coolant level is being
checked because the coolant has
overheated, also check the level in
the radiator and top off if
necessary.
• In an emergency, distilled water
can be added to the cooling
system. However, the coolant
must then be drained and
replenished with HD4X
Hybrid OAT coolant as soon as
possible.
Refit the final drive belt cover as follows:
Align the cover to the crankcase. Install and
tighten the four screws to
80 lbf in (9 Nm) .
Coolant Change
Have the coolant changed by an authorized
Triumph dealer in accordance with scheduled
maintenance requirements.
Warning
Do not remove the expansion tank cap or
radiator pressure cap when the engine is
hot. When the engine is hot, the coolant
inside the radiator will be hot and also
under pressure. Contact with this hot,
pressurized coolant will cause scalds and
skin damage.
2
2
f
1
Caution
If hard water is used in the cooling system,
it will cause scale accumulation in the
engine and radiator and considerably
reduce the efficiency of the cooling system.
Reduced cooling system efficiency may
cause the engine to overheat and suffer
severe damage.