3 of 4
4.
Insert the M10 x 40 mm bolts from the outside so that
the threaded ends of the bolts face inwards. Fit a M10
lock nut to the bolt on the left hand side of the
motorcycle and tighten to
45 Nm
.
1. Bolts
2. Centre stand
5.
Recover the shim from the kit and attempt to insert it
(without using force) between the mounting bracket
on the frame and the centre stand, on the right hand
side of the motorcycle.
1. Shim
2. Centre stand
3. Frame mounting bracket
6.
If the shim does not slide freely between the stand and
the frame, discard the shim and continue from step 7. If
the shim slides freely between the stand and the
frame, install it as described below:
• Remove the bolt on the right hand side of the
motorcycle, withdraw the flanged sleeve and fit the
shim between the frame mounting bracket and the
centre stand. Refit the flanged sleeve.
• Refit the bolt as described in step 4, fit the lock nut
and tighten to
45 Nm
.
• Check the operation of the centre stand, ensuring
the stand operates freely and properly. If the stand
does not operate freely, remove the shim, fit a new
lock nut (supplied) and tighten to
45 Nm
. Continue
from step 8.
7.
If the shim is not required, fit the lock nut to the bolt
on the right hand side of the motorcycle and tighten to
45 Nm
.
8.
Fit the spring into the smaller hole in the C-bracket.
1. Spring
2. C-bracket
1
2
cdjv
1
2
cdjv
3
Warning
Installing the shim by force will prevent the centre stand
from retracting fully, or may result in damage to the frame
or centre stand. Riding the motorcycle with a centre stand
which does not retract fully, or with a damaged frame or
centre stand, may interfere with the rider and could affect
the stability or other aspects of the motorcycle’s operation
which may result in loss of motorcycle control and an
accident.
TT908.CS.06
1
2
