4 of 10
Motorcycles Without Panniers
5.
Remove the two nuts and bolts and remove the two
rear pannier mount plates. Retain the nuts and
pannier mount plates for re-use. Retain the bolts for
re-use if the motorcycle is to be returned to its
original condition.
1. Left hand bolt
2. Right hand nut
3. Pannier mount plate (left hand shown)
Note:
•
Lock nuts can be re-used providing resistance can
be felt when the locking portion passes over the
thread of the bolt or stud.
Always use the correct replacement lock nut as
recommended in the Triumph parts catalogue.
6.
Using the carriage plate mounting brackets,
M8 x 65 mm bolts and the spacers from the kit with
the pannier mount plates and the nuts removed
earlier, fit the carriage plate mounting brackets
loosely to the inner side of the subframe as shown
below. Do not tighten fully at this stage.
1. Bolt, M8 x 65 mm
2. Spacer
3. Pannier mount plate
4. Carriage plate mounting bracket (left hand shown)
5. Nut
Caution
Failure to fit the spacers will prevent correct fitment of
the Triumph accessory D-lock.
1
2
3
1
2
3
4
5
