3 of 10
Sliding Carriage - A9508148
1.
Position the motorcycle on a paddock stand.
2.
Remove the rider’s seat as described in the owner’s
handbook.
3.
Remove the four fixings, retain for re-use and
remove the rear rack moulding.
1. Rack moulding
2. Screws
4.
Using the locating marks on the underside of the
rear rack moulding, drill four 25 mm diameter holes,
removing any burrs left from the drilling.
1. Rack moulding
2. Original screw holes
3. Drilled holes, 25 mm diameter
Warning
The accessory kits covered in this instruction are
designed for use on specific models of Triumph
motorcycle. The accessory kits and the models
applicable are listed at the start of the instruction. They
should not be fitted to any other Triumph model or to
any other manufacturer’s motorcycle. Fitting an
accessory kit to a Triumph model not listed, or to any
other manufacturer’s motorcycle will affect the
performance, stability and handling of the motorcycle.
This may affect the rider’s ability to control the
motorcycle and could cause an accident.
Warning
Always have Triumph approved parts, accessories and
conversions fitted by a trained technician of an
authorised Triumph dealer. The fitment of parts,
accessories and conversions by a technician who is not
of an authorised Triumph dealer may affect the
handling, stability or other aspects of the motorcycle’s
operation which may result in loss of motorcycle control
and an accident.
Warning
When fitting this accessory kit, ensure that the
motorcycle is stabilised and adequately supported to
prevent risk of injury from the motorcycle falling.
Warning
Failure to tighten any of the fasteners to the correct
torque specification may result in loss of motorcycle
control and an accident. Always use a calibrated torque
wrench.
Caution
Care must be taken when working on the rear rack
moulding. Damage to the moulding may result from
inadequate care while drilling the holes.
Caution
To ensure the security of the seat release mechanism, if
the motorcycle is reverted to its standard condition, a
new rear rack moulding must be fitted.
1
2
2
4
1
2
2
3
