Troubleshooting
8-2
Indicators During Sending/Receiving Operation
The
Processing
and
Memory
indicators show the fax
transmission status.
• The
Processing
indicator blinks when the machine
is sending/receiving a fax.
• The
Memory
indicator blinks when source data is
being stored in memory for memory transmission.
• The
Memory
indicator is lit when there is source
data stored in the memory for delayed
transmission.
Responding to an ATTENTION Indicator Flashes
If an
ATTENTION
indicator flashes, press [Status/Job Cancel] to check an error message. If the message is not
indicated on the Message Display when [Status/Job Cancel] is pressed or the
ATTENTION
indicator flashes,
check the following.
Symptom
Checkpoints
Corrective Actions
Reference Page
Cannot send fax.
Is the modular cord
connected correctly?
Connect the modular
cord correctly.
—
Is Permitted FAX No. or
Permitted ID No.
registered correctly?
Check Permitted FAX
No. and Permitted ID
No..
6-30
Has a communication
error occurred?
Check error codes in the
TX/RX Result Report
and Activity Report. If
the error code starts with
"U" or "E", perform the
corresponding
procedure.
Appendix-12
Is the destination FAX
line busy?
Send again.
—
Does the destination
FAX machine respond?
Send again.
—
Is there an error other
than above?
Contact your Service
Representative.
—
Содержание P-C2665
