Triton Unichrome Avon, Инструкция по установке и эксплуатации, Страница: 8 / 20

Avon thermostatic mixer shower
6
Height of
sprayhead
and shower
to suit user’s
requirement.
Shower can
be mounted
either side of
the shower
head.
PREPARING THE MIXER VALVE
Check the contents to ensure all parts are
present.
Before commencing the installation, make sure
all the apertures on the valve are carefully
covered to prevent ingress of any debris etc.
The shower valve is suitable for installation in a
chased out cavity in a solid wall, a stud partition
wall, dry lined wall or fixing to a shower cubicle
or panel.
The hot and cold water pipes should not be
permanently attached to the wall within a
metre from the valve prior to installation to
allow for final adjustment of the valve position.
SITING OF THE SHOWER
WARNING: THE SHOWER MUST NOT BE
POSITIONED WHERE IT WILL BE SUBJECT TO
FREEZING CONDITIONS.
Refer to fig.6 for correct siting of the shower.
Position the shower and sprayhead on the wall
so that all controls can be comfortably reached
whilst using the shower. The sprayhead can be
positioned either side of the shower.
The unit must be positioned vertically with the
outlet port at the top of the brass body (marked
with an ‘arrow’).
Important: The hot entry port is stamped
‘HOT’ on the mixer body.
Fig.6
(
diagrammatic view – not to scale)
250mm approx.
Channel for incoming
pipework (rising shown)
Channel for outlet
pipe to fixed head or
bulkhead fitting
Recess at least
60mm deep
Recess for valve
body at least
65mm deep
Fig.7