10
GB
Fit the Tube Closer (33) into the rear chassis tube,
as shown.
Attach the Switch-Box (34) to the front brace by
screwing the Self-Tapping Screws (35) into the
lower holes in the rear of the switchbox (Fig. 28).
Depress the planers trigger and fit the Trigger Strap
(36) (Fig. 29).
Do not leave the trigger permanently locked on.
When you have finished work for the day release
the trigger strap and allow the spring in the trigger
to relax.
Make sure the switch is off (Fig. 31) and plug the
planer into its switchbox, then bring power to the
switchbox via a 10 Amp extension lead. Using a
separate lead to that of your Workcentre enables
independent operation of your saw and planer.
Press the switch with your finger to switch the
power 'ON' (Fig. 30). Tap the stop plate with your
hand to switch it 'OFF' (Fig. 31).
Push the Dust Hose (37) through the hole in the top
of the chassis and position it over your planers dust
outlet (Fig. 32).
Bend the hose over and secure it using the Plastic
Chain (38) twist locked through the slots in the
chassis edge, as shown.
Fit the Dust Bag (39) over the end of the hose and
tighten the draw string (Fig. 33).
As the bag fills, during use, be sure that it is seated
on the ground. Relocate the bag further down the
hose if necessary.
Fig. 27
Fig. 28
Fig. 29
Fig. 30
Fig. 31
Fig. 32
Fig. 33
Assembly
