Triton DENE CONCENTRIC Mini Mixer, Инструкция по установке и эксплуатации

Страница: 12 / 20

Concentric thermostatic mini mixer shower
12
Flow regulator
Angled top
section
Flow Regulation
If a flow regulator has been supplied for use with
high-pressure water systems, place it into the
bottom of the outlet adaptor. Please note the
flow regulator is only designed to work in one
direction
(fig.13) .
COMMISSIONING
Start the water flow by rotating the flow control.
Make sure that both the hot and cold water
supplies are fully open and at (or near to) their
design temperature and pressures and are within
the requirements as stated on
page 5 .
Make sure the temperature control is at the
maximum temperature setting.
Allow the shower to run at the maximum
temperature setting until the water temperature
has stabilised. Rotate the temperature control
until your desired maximum showering
temperature is reached.
The mixer shower has a temperature stop
to prevent accidental rotation to higher
temperatures. This is adjustable to provide a
maximum temperature of 35°C – 40°C and
should be checked on site to guarantee user
safety.
The following is recommended for domestic
installations but must be carried out for
commercial installaions: Check the thermal shut
off facility of the mixer shower by performing a
thermal shut off test.
Shut off the cold supply. The flow from the mixer
shower should stop immediately or reduce to
a trickle in which case the water temperature
should be less than 43°C. In either case, there is
no risk of scalding.
If, however, the temperature is above 43°C then
it is likely there is contamination in the mixer
shower stopping it from shutting off the hot
supply. In this case refer to the maintenance
section or contact Triton Customer Experience.
Fig.13
Water flow
leaving mixer
Outlet adaptor
Insert in this direction
Note: The angled top section of the flow
regulator MUST be facing the outgoing
direction of the water leaving the mixer.