C o m m i s s i o n i n g
14
Replace the temperature control by push fitting
onto the splined spindle. When fitting the
temperature control, the pointer must relate to
the ‘5’ on the temperature scale when the cover
is fitted
(fig.25)
. Refit the retaining screw and
push fit the cover trim back into place.
Switch the electricity supply back on at the
mains. Make sure both water supplies are still
turned on.
Once the installation of the riser rail is complete,
the shower is ready for normal operation.
TEMPERATURE CONTROL SPINDLE
SETTING
Occasionally the spindle may need adjusting
when the temperature control and cover are
removed from the unit. To reset the spindle to
its correct alignment, please refer to the
following:
With the cover and control knob removed, use
your fingers to adjust the splined spindle until
the black line on the spindle lines up with the
groove in the top of the valve spindle housing
(fig.26)
.
Refit the cover. When fitting the temperature
control, the pointer must relate to the ‘5’ on the
temperature scale when the cover is fitted
(fig.25)
.
Note:
Incorrect positioning will result in
excessive cold bleed.
Groove
Black line
Fig.26
Fig.25
