Power shower
15
OPERATING THE SHOWER
Check all plumbing and electrical supplies are
connected and switched on.
To start the shower, rotate the flow control
anti-clockwise from the ‘stop’ position
(fig.29)
.
Adjust the control until the flow rate is
satisfactory.
For maximum flow, turn the flow control fully
anti-clockwise to the ‘max’ position.
To adjust the temperature, rotate the control
(fig.30)
. The temperature is numbered for ease
of use. The temperature ranges from-‘1’ – fully
cold to ‘9’ – fully hot.
Once the preferred temperature is reached, no
further adjustment is required, providing the hot
and cold water supplies remain constant.
To stop the shower, return the flow control
to the ‘stop’ position by rotating clockwise
(fig.31)
. This stops the pump and water flow.
Unless the shower is to be used again
immediately, the shower should also be switched
off at the electricity isolating switch.
As a safety feature, the temperature control
has a built-in stop to prevent you accidentally
exceeding your highest desired temperature. If
adjustment is required see section
‘Adjusting the
maximum temperature stop’
.
To override this stop, depress the button
(fig.32)
while the control is up against the stop
and turn the control anti-clockwise to the higher
settings (pressing the button before the stop will
not operate the override mechanism even if the
control is turned with the button depressed).
To return to the normal temperature range just
turn the temperature control clockwise until it
is past the maximum temperature stop. Make
sure the temperature control is in the normal
temperature range when the shower is switched
off. The stop comes in a factory set position
based on 65°C stored hot water temperature.
Note:
As the flow control is adjusted it is normal
for the sound of the pump to alter in pitch.
Flow
control
Flow
control
Temperature
control
Override
button
Temperature
control
Fig.29
Fig.31
Fig.30
Fig.32
