Electric shower
8
FITTING THE SHOWER TO THE WALL
Note:
The control knobs are an integral part of
the cover – DO NOT attempt to remove them.
Lift the cover from the backplate and remove the
trimplate..
Entry positions for the mains water and electric
cable are from the top, bottom, either side or
from the back.
Note:
Deviations from the designated entry
points will invalidate product approvals.
If a bottom entry has been chosen, the pipe trim
on the bottom of the cover should be removed
(fig.7)
.
If a top entry has been chosen, the pipe trim
on the top of the backplate should be removed
(fig.8)
.
If a side entry is required, the trimplate side will
have to be cut. With the elbow compression
fitted on the outlet, temporarily place the
trimplate into position, then mark the pipe entry
on the side of the trimplate. Carefully remove
the appropriate area using a junior hacksaw.
WARNING!
Check there are no hidden cables or
pipes before drilling holes for wall
plugs. Use great care when using
power tools near water. The use of
a residual current device (RCD) is
recommended when using power tools.
20 mm
T00314
T00315
Please note: NONE of the 'cut outs' are
designed to 'snap out'. DO NOT remove
using pliers as the backplate or lower
trimplate could be damaged.
A junior hacksaw or suitable knife should
be used and any rough edges removed.
Damage to the backplate or lower
trimplate will invalidate product
specifications and warranty.
Fig.8
Fig.7
Fig.9
