XM787-V1.0.0-NR
26
80-84
All motor reset
85-87
Scan motor reset
88-90
no function
91-93
Edit and store white balance enabled
94-96
no function
97-99
Others motor reset
100-119
Internal program 1 (secne1~8 of EEPROM)
120-139
Internal program 2 (secne9~16 of EEPROM)
140-159
Internal program 3 (secne17~24 of EEPROM)
160-179
Internal program 4 (secne25~32 of EEPROM)
180-199
Internal program 5 (secne33~40 of EEPROM)
200-219
Internal program 6 (secne41~48 of EEPROM)
220-239
Internal program 7 (secne49~56 of EEPROM)
240-255
Music Control (secne of Program 1)
34
18
48
Pan Fine 16bit
0-255
Fine control of Pan movement
35
19
49
Tilt Fine 16bit
0-255
Fine control of Tilt movement
10. ERROR MESSAGE
When you turn on the fixture, it will make a reset at first. The display may show“Err channel is
XX” while there are problems with one or more channels. “XX” stands for channel 1, 2, 3, 4, 5,
6 who has the testing sensor for positioning. For example, when the display shows “Err channel is
red led”, it means there is some error in channel 1. If there are some errors on channel 1, channel
5, channel 6 at the same time, you may see the error message, “Err channel is red led” “Err
channel is Pan movement”, “Err channel is Tilt movement” ,flash repeated for 2 times, and then
the fixture will generate a second reset. If the fixture remain error message after performing reset
more than 2 times, only the channels which have errors can not work properly, others can work as
usual. Please contact with dealer or manufacturer for service, self repair is not allowed.
PAN- movement Er
(PAN-yoke movement error) This message will appear after the reset of the fixture if the yoke’s
magnetic-indexing circuit malfunction (sensor failed or magnet missing) or the stepping-motor is
defective (or its driving IC on the main PCB). The PAN-
movement is not located in the default
position after the reset.
TILT- movement Er
(TILT-head movement error) This message will appear after the reset of the fixture if the head’s
magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the stepping-motor
is defective (or its driving IC on the main PCB). The TILT-
movement is not located in the
default position after the reset.
