Tritech International Ltd
Super SeaSpy Camera OIM
Issue 0
TIL --- Eng --- Spec --- 098
Page
12 of 19
The camera can be set up to allow either of two different analogue control methods for manual light control
via the use of solder splashes on the top of the PSU PCB.
Solder splash jumper points are also used to configure the line driver options.
These are detailed below with the standard DEFAULT settings highlighted.
NOTE
Upon initial power up the Super Seaspy camera will start up in
Dynamic Light Control
mode
. This means that the ring led’s will react automatically to any changes in the
reflectivity of the work surface or scenery ambient light conditions: - In darker areas the ring
led’s will brighten and the reverse in lighter areas.
Manual control mode
of the ring led’s can be obtained by applying an analogue voltage to +/- LIGHT line
(PIN1
on Tritech connector).
If you wish to return to Dynamic Light Control mode, after making a manual control input, the camera must be
switched OFF for several seconds. Upon switching ON again the camera will revert to Dynamic Light Control
Mode.
SS2 MANUAL ELECTRONIC LIGHT CONTROL SETUP:
FOR +\- SINGLE WIRE (Tri-State Control)
Link solder pads 2 & 3 together
+/- LIGHT is supplied with +5 to +24 volts, LED’s Brighten
+/- LIGHT is linked to 0 volts, LED’s DIM
+/- LIGHT is left un-connected, LED’s remain constant
FOR +\- SINGLE WIRE (Bi-polar Control)
DEFAULT SETTING
+/- LIGHT is supplied with +5 to +24 volts, LED’s Brighten
+/- LIGHT is supplied with -5 to -24 volts, LED’s Dim
+/- LIGHT is left un-connected or 0 volts, LED’s remain
constant
Содержание Super SeaSpy PCAM1Z-S
Страница 2: ......
