Tristar Products Power AirFryer Pro Elite TXG-DT10L, Руководство пользователя

Страница: 9 / 24

Power AirFryer Oven Elite™ | Model: TXG-DT10L
9
Using the Accessories
Rotisserie Spit Assembly
& Insertion
Rotisserie Shaft & Skewers Racks
1. Place the two Skewer Racks at each end of
the Rotisserie Shaft. Make sure the Set Screws are
on the outer side of the Rotisserie Shaft (FIG. D).
2.
Slightly tighten Set Screws. Do not overtighten as
you may need to adjust the tightness after
you insert the Skewers.
3. Carefully poke Skewers through food.
1. Slide a Skewer into an open slot on the edge of
the Skewer Rack with the clip facing toward the
Rotisserie Shaft.
2. Guide the sharp end of the Skewer through the hole
on the opposite Skewer Rack and push the clip
through the hole near the slot until the Skewer is
secure (FIG. E).
3.
Repeat steps 1–2 in a uniform manner around the
Skewer Rack. Make sure Skewers
are evenly spaced (FIG. F).
4. Tighten the Set Screws to make sure they
are securely in place.
5.
Use caution while inserting the Spit into the Unit to
prevent getting poked by the Skewer ends.
6. Open the door of the Unit. Slide the Rotisserie Spit
onto the rails in the center of the Unit.
7. Slide the switch on the left side of the Unit to the
right and hold the switch in place while pushing the
Rotisserie Spit as far back into the Unit as possible
(FIG. G).
8.
Release the switch. The switch should slide
back into the left position, and the left side of the
Rotisserie Spit should be locked in place.
FIG. D: Assembling Skewer Racks and Rotisserie Shaft
FIG. E: Clipping Skewers into Skewer Racks
FIG. F: Fully assembled Rotisserie Spit
FIG. G
: Hold switch in left position to insert/remove Rotisserie Spit