23
WARNING:
Never touch hot soleplate at any time before cooling down!
Steam ironing
1.
Put the unit base on a stable and level surface.
2. Open the water inlet cover, then fill the water tank with water through the filling
aperture. You had better use purified water with less calcium particles. The max
capacity of water tank is 2.0L, the water level shall not be exceeded the MAX mark.
3. Put the iron on the thermal insulation stand of unit base.
4. Connect plug to the wall outlet, turn the temperature dial and the defaulted MAX
steam rate indicator lights solidly. There are two modes including MAX and ECO
steam rates available, you can select the desired steam rate for each garment
according to your requirement. Make sure that there is enough water in the tank.
5. Turn temperature dial to select your desired temperature setting, which is depended
on the fabric of garment, and the iron starts heating. Refer to
“IRONING TIPS”
and
“ADDITIONAL TABLE”
as below when select temperature.
6. After a few minutes, the temperature indicator will extinguish, it indicates the
soleplate temperature has achieved the selected temperature, it indicates that the
iron is ready for ironing garment with steam.
7. Press the steam trigger with a little force, the steam will be sprayed from the
soleplate continuously, and then you can iron the garment with steam.
Note:
There may be dripping water during spraying steam when the temperature is at
and lower than the second setting. This is normal.
Cautions:
1) Do not touch hot soleplate at any time before cooling down!
2) Never direct the steam at people!
3) Do not activate the steam button when the iron is placed on the unit base to avoid
being scalded by steam.
8. After ironing, remove the plug from the wall socket, the appliance will be turned
off and all the indicators will extinguish, then unplug the appliance. But the
soleplate is still hot, never touch it with hand, place it on the thermal insulation
stand until it cools down completely.
