8T
Horizontal Mount
(612 & 1250 models only)
Using the measurements from the diagram, install two user-sup-
plied ¼" (6 mm) fasteners into a rigid horizontal surface, leaving
the heads slightly raised.
Slide the UPS System back over the
fasteners to engage the mounting slots molded on the bottom of the
UPS System cabinet.
Install and tighten two user-supplied ¼"
(6 mm) fasteners into the mounting feet molded on the front of
the UPS System cabinet.
Horizontal Mount
(1012 and 2012 models only)
Using the measurements from the diagram, install two user-sup-
plied ¼" (6 mm) fasteners into a rigid horizontal surface, leaving
the heads slightly raised.
Slide the UPS System forward over
the fasteners to engage the mounting feet molded on the front of
the UPS System cabinet. Install and tighten additional user-sup-
plied ¼" (6 mm) fasteners into the mounting feet molded on the
rear and sides of the UPS System cabinet*. The rear feet extend
beyond the unit’s cabinet to provide for adequate ventilation
space behind the cooling fan(s); they should not be removed.
5.87 in.
(14.91 cm.)
1.64 in.
(4.15 cm.)
5.87 in.
(14.91 cm.)
5.57 in.
(14.16 cm.)
5.57 in.
(14.16 cm.)
9.59 in.
(24.35 cm.)
9.59 in.
(24.35 cm.)
6.75 in.
(17.1 cm)
7.87 in.
(20 cm)
6.75 in.
(17.1 cm)
4.5 in.
(11.4 cm)
A
C
B
M
A
B
M
A
B
C
A
B
Note: Cabinets may have different front panel features, but all mount as per the figure above, or via the Lateral Mounting
Bracket, illustrated at left.
* All models include front and rear mounting feet. Select
models include side mounting feet.
Mounting
WARNING! Mount your UPS System BEFORE DC battery and AC power
connection. Failure to follow these instructions may lead to personal injury
and/or damage to the UPS System and connected systems.
Tripp Lite manufactures a variety of UPS Systems with a variety of mounting options. Tripp Lite recommends permanent mounting of your UPS
System in any of the configurations illustrated below. User must supply mounting hardware and is responsible for determining if the hard-
ware and mounting surface are suitable to support the weight of the UPS System. Contact Tripp Lite if you require further assistance in
mounting your UPS System.
