Features
MRV2012UL serves as an automotive or stationary DC-to-AC inverter with automatic line-to-battery transfer and integrated battery charger
Supports 120V AC output from a 120V AC line power source or 12V DC battery source
16.6 millisecond automatic transfer between line and battery power supports UPS protection during blackouts and voltage fluctuations for
equipment compatible with a one cycle transfer time
2000 watts continuous AC output in inverter mode, 3600 watts continuous AC output in AC line power mode
DoubleBoost inverter output supports momentary startup loads up to 200% of the continuous rating for up to 10 seconds
OverPower inverter output supports longer duration overloads to 150% for up to 60 minutes under ideal battery and temperature conditions.
(For best results, utilize OverPower usage for as short of a duration as possible, ensure battery bank and cabling is able to provide full
nominal DC voltage under load and allow inverter/charger to fully cool before and after OverPower usage.)
3-stage battery charger with user-selectable 25/100 amp operation and adjustable settings for wet/gel battery types with charger on/off
capability; offers fast, reliable battery recharging
Protected hardwire DC terminal posts safely accept heavy-gauge input wiring from attached battery bank
Protected hardwire output passes 120V line power or inverter output through to connected equipment
Extremely reliable large-transformer design tested to UL (USA & Canada) standards
Moisture-resistant construction enables vehicular operation in high-humidity environments
3-position operating mode switch supports "AUTO" mode to enable automatic transfer between DC and AC modes, CHARGE-ONLY to
maintain a full battery charge when AC is present without auto transfer and SYSTEM OFF settings
Six front panel LEDs display AC/DC operational modes, overload status, DC voltage level, shutdown status and system fault status
4 configuration dip-switches support wet/gel battery charging profiles, charger enable/disable capability, selectable 75/85/95/105V AC low
voltage auto transfer points during brownout conditions
4 additional configuration dip-switches support 4 levels of charger limiting relative to output load size, a battery equalization program and
battery charger low/high settings
Resettable 25A charger AC input breaker and variable-speed cooling fan protect the inverter from load- and temperature-related failures
Grounding lug properly connects the inverter/charger system to earth ground or vehicle grounding system
Automatic overload and thermal shutoff safely turns off inverter as excessive loads or overheating conditions develop
Front panel connector enables remote off/on switching (requires optional APSRM4 remote control module, sold separately)
Load-sensing control dial enables adjustable load threshold required to automatically turn the inverter on and off in DC mode as load
conditions change
Includes battery temperature sensor with 20 foot cable to prolong battery life by adjusting the charge level based on battery temperature
Automatic Generator Starter jack enables user configuration of automatic generator startup as inverter batteries drop to 11.5V DC and
generator shutoff as inverter batteries are recharged to 14.1V DC
Specifications
OVERVIEW
Intended Application
RV/Fleet/Alternative Power
OUTPUT
Frequency
compatibility
60 Hz
Output watts
2000
Continuous output
capacity (watts)
2000
Peak output
capacity (watts)
4000
Output nominal
voltage
120V
Output voltage
regulation
LINE POWER (AC): Maintains 120V nominal sine wave output from line power source. INVERTER POWER (AC):
Maintains PWM sine wave output voltage of 120V AC (+/-5%).
Output frequency
regulation
60 Hz (+/- 0.3 Hz)
Overload protection
Includes 25A input breaker dedicated to the charging system
