Tripp Lite NFI-U05, Руководство пользователя

Страница: 10 / 20

10
Wiring Requirements
WARNING:
Safety measures should be taken before connecting
the power cable. Turn off the power before connecting modules
or wires. The correct power supply voltage is listed on the product
label. Check the voltage of your power source to make sure you
are using the correct voltage. DO NOT use a voltage greater than
what is specified on the product label.
• Use minimum 24AWG power cable wire when connecting.
• Use a Power Supply that provides a Limited Power Source.
These power supply are generally marked LPS.
• Be sure to observe the polarity when connecting. Not following
polarity can damage your unit and void your warranty.
Please read and follow these guidelines:
• Use separate paths to route wiring for power and devices. If power
wiring and device wiring paths must cross, make sure the wires are
perpendicular at the intersection point.
Note: Do not run signal or communications wiring and power wiring through the
same wire conduit. To avoid interference, wires with different signal characteristics
should be routed separately.
• You can use the type of signal transmitted through a wire to determine
which wires should be kept separate. Wiring that shares similar electrical
characteristics can be bundled together.
• You should separate input wiring from output wiring.
• Be advised that you should label the wiring to all devices in the system.