2
1-1 Parts List
A
Water Sensor
B
Cover
C
22 AWG Cable, 15 ft. (4.6 m)
D
Owner’s Manual
E
Double-Sided Adhesive Tape
1-2 Tools Required
A
Wire Cutters
B
Wire Strippers
C
Phillips Screwdriver
D
Flathead Screwdriver
1-3 Specifications
Electrical
Voltage:
5~24V DC
Standby Current:
1 mA
Alarm Current:
200 mA
Contact Closure Type: Normally Open
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that must be followed during the installation and operation of the products
described in this manual. Read all instructions and warnings thoroughly before attempting installation. Failure to comply may
invalidate the warranty and cause property damage and/or personal injury.
1 – Introduction
2 – Important Safety Instructions
The E2SLD leak detection sensor is designed to detect water leakage or leakage of any electrically conductive fluid. The E2SLD supports a
Normally Open contact closure connection. It must be used with a compatible Tripp Lite UPS or PDU equipped with the WEBCARDLX or
LX Platform interface, along with a compatible E2 environmental sensor module (both are sold separately).
• Install in a controlled indoor environment, away from moisture, temperature extremes, flammable liquids and gasses, conductive contami-
nants, dust and direct sunlight.
• Provide suitable grounding in accordance with all applicable electrical wiring regulations.
• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the life
support equipment or to significantly affect its safety or effectiveness is not recommended.
A
A
B
C
D
B
C
D
E
