16
11
Using Cat5e/6 cable, connect the RJ45 port on the repeater unit
marked
OUTPUT
to the RJ45 port on the B126-2A0 receiver unit
marked
INPUT
.
12
Connect a monitor to the
OUTPUT 1
port on the receiver unit using a
Tripp Lite P568-Series High-Speed HDMI Cable.
13
Repeat step 12 for the
OUTPUT 2
port on the receiver unit.
14
Connect the external power supply to the receiver unit and plug the
receiver unit into a Tripp Lite Surge Suppressor, Power Distribution
Unit (PDU), or Uninterruptible Power Supply (UPS). The green RJ45
LED illuminates to indicate that it is receiving power from the external
power supply.
15
Repeat steps 5 through 14 for each additional RJ45
OUTPUT
port on
the transmitter unit.
16
Turn on the power to the connected devices. The orange RJ45 LEDs
on all units will illuminate to indicate that a signal is being received
from the HDMI source. The video image should now be displayed on
the connected monitors.
17
If necessary, use the
Equalization
control on the repeater and receiver
units to adjust the video image.
Note:
An improper Equalization
setting can cause the monitor not to display an image at all. Try each
setting until an acceptable image is displayed.
Extender/Splitter with
Remote/Repeater Installation
13-08-043 93-32D0.indd 16
8/28/2013 2:17:41 PM
