12
7
Connect the external power supply to the receiver unit and plug the
receiver unit into a Tripp Lite Surge Suppressor, Power Distribution Unit
(PDU), or Uninterruptible Power Supply (UPS). The green RJ45 LED
illuminates to indicate that the unit is receiving power from the external
power supply.
8
Connect a monitor to the
OUTPUT 1
port on the receiver unit using a
Tripp Lite P568-Series High-Speed HDMI Cable.
9
Repeat step 8 for the
OUTPUT 2
port on the receiver unit.
10
Turn on the power to the connected devices. The orange RJ45 LEDs
on the transmitter and receiver units will illuminate to indicate that
a signal is being received from the HDMI source. The video image
should now be displayed on the connected monitors.
11
If necessary, use the Equalization control on the receiver unit to adjust
the video image.
Note:
An improper Equalization setting can cause
the monitor not to display an image at all. Try each setting until an
acceptable image is displayed.
Standard Extender/Splitter Installation
13-08-043 93-32D0.indd 12
8/28/2013 2:17:40 PM
