12
Extender Kit with Remote/Repeater Installation
11
To add a third remote/repeater unit, repeat steps 8 through 10.
To finish your installation with the B126-1A1 or B126-1A1-WP
remote receiver unit, proceed to step 12.
12
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the last
remote/repeater unit to the RJ45 INPUT port of the B126-1A1 or
B126-1A1-WP remote receiver unit.
13
Connect a monitor to the HDMI OUTPUT port on the remote receiver
unit using a Tripp Lite P568-Series HDMI Cable.
14
Connect the external power supply to the remote receiver unit and
plug it into a Tripp Lite Surge Suppressor, PDU or UPS. The green
LED illuminates to indicate the unit is receiving power from the
external power supply. The orange LED illuminates to indicate the
unit is connected to a powered ON remote/repeater unit.
15
Turn on the power to the HDMI source. The orange LED on the
local unit illuminates to indicate a signal is being received from the
source.
16
If necessary, use the Equalization control on the remote/repeater
unit(s) and remote receiver unit to adjust the video image.
Note:
An
improper Equalization setting can cause the monitor not to display
a picture at all. Try each Equalization setting until an acceptable
picture is displayed.
201109206-93-3023-EN.indd 12
10/24/2011 10:01:21 AM
