19
AUDITING: Dumping the Event Log
Note:
The following steps are intended for the system administrator.
The Event Log is a detailed report of critical activities stored in the KVM or
KVM memory. To view or dump the Event Log, follow the instructions below.
Note:
Only one computer connected to port 1 is required for this operation.
1.
Open the Administration and Security Management Program (See the
EDID Learn section for download instructions). The Administration and
Security Management screen will appear.
2.
Initiate the session by pressing the following hotkey command. Hit each
key one after another.
[Alt][Alt][c][n][f][g]
3.
Upon completing the command, the mouse connected to the KVM will
stop functioning. A prompt will appear to enter the Credential ID.
4.
Log in by entering the default username
admin
and pressing Enter.
5.
Enter the default password
12345
and press Enter.
6.
Request a Log Dump by selecting option 5 in the menu.
Miscellaneous KVM Functionality
18-06-260-933845-EN.indd 19
8/10/2018 2:43:54 PM
6
Important Safety Instructions
• Read all instructions and save them for future reference.
• Follow all warnings and instructions marked on the device.
• Do not place the device on any unstable surface (cart, stand, table, etc.).
If the device falls, serious damage will result.
• Do not use the device near water.
• Do not place the device near, or over, radiators or heat registers. The
device cabinet contains slots and openings to allow for adequate
ventilation. To ensure reliable operation and to protect against
overheating, these openings must never be blocked or covered.
• The device should never be placed on a soft surface (bed, sofa, rug, etc.)
as this will block its ventilation openings. Likewise, the device should not
be placed in a built-in enclosure unless adequate ventilation has been
provided.
• Never spill liquid of any kind on the device.
• Unplug the device from the wall outlet before cleaning. Do not use liquid
or aerosol cleaners. Use a damp cloth for cleaning.
• The device should be operated from the power source type as indicated
on the marking label. If you are not sure of the type of power available,
consult your dealer or local power utility.
• Do not allow anything to rest on the power cord or cables. Route the
power cord and cables so that they cannot be stepped on or tripped over.
• If an extension cord is used with this device, make sure the total ampere
rating of all products used on the cord does not exceed the extension
cord ampere rating. Make sure the total rating of all products plugged into
the wall outlet does not exceed 15 amperes.
• Position system cables and power cables carefully. Make sure nothing
rests on any cables.
• To help protect your system from sudden transient increases and
decreases in electrical power, it is recommended you plug your devices
into a Tripp Lite Surge Protector, Line Conditioner, or Uninterruptible
Power Supply (UPS).
18-06-260-933845-EN.indd 6
8/10/2018 2:43:53 PM
15
