5
Important Safety Instructions
Connection and Start-Up
Plug your UPS’s line cord into an
electrical outlet.
Your UPS must be connected to a dedicated
circuit of sufficient amperage. Note, however,
that the select models may be fitted with
different plug types. Refer to the “OP Rating/
Plug Rating” chart printed on the top of your
UPS.
Once your UPS is plugged in, the fan and all
Indicator Lights will turn ON. The “LINE” and
“LOAD ACTIVE METER” LEDs will illuminate
and the UPS will emit a beep to indicate normal
operation. However, power is not supplied to
your UPS’s AC outlets until the UPS is turned on.
Plug your equipment into your UPS.
Your UPS is designed to support audio/video
systems and their associated servers, Media
Center PCs, and a Tripp Lite HT3100PC Power
Conditioning Center only. The total number of
components connected should not exceed UPS
capacity. This will overload your UPS system.
You will also overload your UPS if you connect
household appliances to the UPS's outlets.
Turn your UPS ON:
• Press the “ON/TEST” Button
• Hold it for several seconds until you hear
a beep
• Release it
Your UPS will begin providing AC power to its outlets.
The “ON LINE” LED will illuminate.
Your UPS will function properly without these
connections.
Phone Line or Phone/Network
Line Surge Suppression
Your UPS has jacks which protect against
surges on a phone line. Select models feature
jacks which also protect against surges on a
network line.* Using appropriate telephone or
network cords connect your wall jack to the
UPS jack marked “IN.” Connect your
equipment to the UPS jack marked “OUT.”
Make sure the equipment you connect to the
UPS's jacks is also protected against surges on
the AC line.
* Not compatible with PoE (Power Over Ethernet) applications.
Your model may differ.
1
1
2
3
2
3
Your model may differ.
Installation
(continued)
Optional Connections
1
1
Your model may differ.
200507084 93-2474 SMARTONLINE HT OM.qxd 10/20/2005 11:11 AM Page 5
