Operation
1.
Install 4 fresh AAA batteries or connect the AC adaptor.
2.
Set-up the datalogger using the software provided.
3.
Connect the voltage test leads or the current probes to the AC source
to be measured.
4.
Press and Hold the START/STOP button for four seconds to start
recording. The “REC” icon will appear in the display indication that
recording has begun.
5.
Press and Hold the START/STOP button for four seconds to stop
recording. The “REC” icon will disappear from the display.
6.
Remove the probe, connect the datalogger to a PC and use the
supplied software to download the data.
Note: If the clock does not set to the correct time, replace the 3V button
battery.
You, as the end user, are legally bound (
Battery ordinance
) to
return all used batteries and
accumulators;
disposal in the household garbage is prohibited!
You can hand over your used batteries / accumulators at
collection points in your community or wherever batteries /
accumulators are sold!
Disposal:
Follow the valid legal stipulations in respect of the
disposal of the device at the
end of its lifecycle.
Software Introduction
1.
Place the CD in the drive and then follow the on-screen installation
instruction.
2.
After the software is installed, keep the CD in the drive and
connect the datalogger to the PC by the USB cable.
3.
A USB Driver installation window will pop-up. Follow the directions to
install the driver.
Download Triplett Product Software — Triplett — Triplett Test Equipment
& Tools
Software Operation
The Software operation is described in the HELP file located on the
software disk.
