28
7.4.4
If the display indicates overrange, i.e.
“1
- - -
”,
disconnect the test probes from the circuit and rotate
the RANGE switch to the next higher position.
Reconnect the test probes to the circuit LCD display. If
the RANGE switch is already at the highest position
(i.e. 600 VAC), the input voltage exceeds the
measurement capability of the meter and should not be
measured.
7.4.5
If the displayed value is less than
“200”
(decimal point
not shown), a more accurate reading may be obtained
by setting the RANGE switch to a lower range.
Disconnect the probes from the circuit and rotate the
RANGE switch to the next lower position. Reconnect
the test probes to the circuit and observe the reading
on the LCD display. If the RANGE switch is already
on the lowest position (i.e. 200m AC), no greater
measurement resolution can be obtained.
www.
.com
1.800.561.8187
