power OFF) set to 10 seconds and Flashlight ON if measuring in a
dimly lit area.
2.
Open the lens protective lens cover by rotating the
cover wheel clockwise
(facing the lens) until the dot
is visible on the wheel.
3.
Hold the meter by its Handle Grip and point it toward
the surface to be measured.
4. Pull and hold the Trigger to
turn the meter on and begin
testing in Scan mode. The
display will light if the
batteries are good. Replace
the batteries if the display
does not light.
5.
Release the Trigger; the reading will HOLD for the time
set in the APO setting. The backlight will turn off after
approximately 4 seconds.
6.
The meter defaults to the programmed conditions in use when the
meter was last switched OFF.
Laser Pointer
The laser pointer circle identifies the area being measured. The size of the
area is determined by the distance to spot ratio. Objects outside the circle
are not measured. The spot measured should always be larger than the
circle for accurate measurements.