3
: Do not keep the machine in the same
position with the pad / brush spinning, or you
could cause damage to the floor.
8
.
Adjust solution flow by adjusting the
position of ball valve knob.
WHILE OPERATING MACHINE
1. Occasionally look through the clear
recovery tank lid to see if there is any
foam build-up. If excessive foam is found,
add defoamer to the recovery tank.
: Foam must not enter the float
shut-off screen, or damage can occur to the
vacuum motor. Foam will not activate the
machines float shut-off device.
2. Occasionally view the clear tube at the
back left of the machine to check the
amount of cleaning solution that is left in
the machine.
If the squeegee assembly leaves streaks on
the floor, raise the squeegee off the floor and
wipe the blades down with a damp cloth.
: Do not use your fingers to wipe or
remove debris from the blades, as injury may
occur.
When the solution tank runs empty, turn off
the brush switch and ball valve of solution
tank. Keep the squeegee down and continue
to vacuum until all the dirty water is picked up.
TANK DRAINING
1. Turn the switches on the control panel to
“off ” position.
2. Raise the squeegee, transport machine to
approved area for draining tank(s).
DRAINING THE RECOVERY (DIRTY) TANK
: Any time scrubbing is completed, or
when refilling solution tank, the recovery tank
should be drained and cleaned.
: If the recovery tank is not drained
when the solution tank has been refilled,
foam or water may enter the float shut-off
mechanism and cause damage to the
vacuum motor.
1. Remove the drain hose from the holder,
and place the drain hose over the floor
drain. Twist off the drain hose plug to
begin the draining process.
2. Clean the recovery tank after every use.
Use a fresh water hose to rinse out the
recovery tank. Be careful not to spray
water into the float shut-off mechanism.
: If you are storing the machine for any
period of time, always leave the clear
recovery tank lid off the tank so the tank can
dry completely and smell fresh.
DRAINING THE SOLUTION (CLEAN) TANK
: Any time scrubbing operation is
completed, the solution tank should be
drained and cleaned.
1. Pull down on the clear tube (back left of
the machine) to remove it from the hose
barb. This will allow the solution to flow
freely into a bucket or floor drain.
2. Rinse the solution tank with clean water
after every use. This will help prevent
chemical buildup and clogging of the
solution lines.
3. Once tank is rinsed, flushed and drained,
reconnect the clear tube to the hose barb.
Be sure the tube is pushed all the way up
on the hose barb.
