2
MACHINE SET UP & INSTALLATION
UNPACK MACHINE
Be sure and check packing carton for any
damage. Immediately report any damage to
carrier. Be careful not to let machine vibrate
while carrying, Check contents of package to
ensure that the following items are included:
Machine, squeegee assembly, pad driver.
MACHINE SET UP
PRE-OPERATION CHECKS
1. Sweep the outside of the machine.
2. Make sure the voltage of machine
conform to local voltage.
3. Check that squeegee is properly installed.
4. Check that brush / pad is properly
installed.
5. Bumper doesn’t touch the floor directly.
The gap between the bumper and the
floor surface can be adjusted by adjusting
sliding plate.
6.
The forward speed of machine can be
controlled by turning the butterfly nut. Turn
the nut clockwise to speed up machine. or
turn the nut anticlockwise to slow down
machine.
7. Make sure the working surface can
support the machine weight, the gradient
of the floor can’t exceed the limit that
machine allow.
INSTALLING PAD DRIVER OR BRUSH
1. Unplug machine.
2. Tilt the machine backwards, line up the
drive pulley hub with the hole of brush or
pad driver, make sure the three blocks are
fitted into the three slots of drive pulley.
3. If a pad driver is being used, the
appropriate pad should be attached to the
pad driver first.
4. Plug power cord into a grounded outlet,
switch on the brush motor and then pull
the operating triggers gently to mount the
pad driver or brush automatically.
INSTALLING THE SQUEEGEE
1. Loosen the two knobs on the squeegee
and slide the squeegee into the slots at
the rear of the squeegee bracket. (the
wheels on the squeegee point to the back)
2. Tighten the knobs securely.
FILLING THE SOLUTION TANK
1. The fill port is located at the rear of
machine.
2. Fill solution tank with water. (water
temperature should not exceed 140° F)
The clear tube in the back left of the
machine has gallon markers to help
determine the water level in the solution
tank
: Do not put any flammable
materials into solution tank. This can cause
an explosion or a fire. Only use
recommended cleaning chemicals. Contact
your janitorial supply distributor for
recommendations on proper chemicals.
MACHINE OPERATION
: Do not operate machine unless you
have read and understand this manual.
1. Adjust control housing to a comfortable
operating height by squeezing together
the two thumb levers directly underneath
the housing.
2. Lower squeegee assembly to the floor.
3. Turn brush motor switch to “on” position.
4. Turn vacuum motor switch to “on” position.
5. Rotate the ball valve of solution tank to
horizontal position. Solution will not begin
to flow until the operating triggers are
pulled.
6. To begin scrubbing, pull on one or both of
the red operating triggers, when these
triggers are pulled, the pad driver will
begin to spin and the solution will begin to
flow.
7. Begin scrubbing by moving the machine
forward.
