Triple S JAGUAR 20R, Руководство пользователя

Страница: 12 / 60

The machine is supplied with cables suitable to install two 12V
pad, make sure all of the switches on machine are
5).
(NOTE: Turn pin 1 and pin 2 of DIP switch
pin 2 to “OFF”)
(NOTE: Turn pin 1 and pin 2
9
A
B
Figure 5
A
C
B
Figure 6
4. Unscrew the screw (B, Figure 4) on control panel, then turn over the PCBA (A) on the panel to find DIP switch (D),
follow Figure 4 for DIP settings.
5. Perform steps in reserve order of disassembly to fix control panel and lock the screw after setting is done.
1
WET BATTERIES
of DIP switch
to “OFF”)
2
DISCOVER EV AGM BATTERIES
(NOTE: Turn pin 1 of DIP switch to “ON”,
3
GENERAL GEL/AFM BATTERIES
to “ON”)
Battery Installation
6. Open the recovery tank cover (4) and check the recovery tank (3) is empty, otherwise, empty it with the drain hose
(15).
7. Close the recovery tank cover (4).
8. Overturn the recovery tank (3) carefully.
9.
batteries. Carefully put the batteries into the compartment,
then install them correctly.
10. Route and install the battery cable as shown in (Figure 3),
then carefully tighten the nut on each battery terminal.
11. Place the protection cap on each terminal, then connect the
battery connector.
12. Carefully lower the recovery tank (3).
Charging the Batteries
13. Charging the batteries. [Refer to MAINTENANCE chapters].
EMERGENCY BRAKING
If there is any emergency during machine operating, press the emergency switch (A, Figure 5), then all functions of
machine will stop, there is no display on control panel (B, Figure
BRUSH/PAD INSTALLATION AND UNINSTALLATION
NOTE
Install suitable brush (A, Figure 6) or Pad (B and
C, Figure 6) according to the type of floor to be
cleaned.
CAUTION
Before installation or uninstallation of brush or
in off position and lifting up the squeegee from
the floor. The operator must be equipped with
suitable personnel protection devices such as
gloves to reduce the risk of accidents. Proceed as
following:
OTHE
R
GEL/A
G
M
DI
S-EV
WE
T
D
A
B
C
Figure 4