ASSEMBLY INSTRUCTIONS
Note: There will be a very small gap in-between two locked SLIP SLEEVES (E)
—
this is normal.
© 2018 TRINITY - 800.985.5506
2
A (5)
E (10)
For easiest assembly, do not connect TOP POLES (C),
MIDDLE POLES (B), and BOTTOM POLES (A) until
instructed. Once connected, these will be the posts for
the Rack.
Note that each POLE (A+B+C) has slight horizontal line
indentations at 1” intervals. Each SLIP SLEEVE (E) has
raised horizontal lines inside designed to lock them in
place on POLE (A+B+C).
On BOTTOM POLE (A), place 1 pair of SLIP SLEEVES (E) at
the desired level no higher than the 3
rd
indentation from
the bottom. Please make sure the arrow faces up and
that the word “TOP” is right side up. Do this for each
BOTTOM POLE (A), and make sure that the heights are
identical for each BOTTOM POLE (A).
Slide the pair of SLIP SLEEVES (E) until you hear a click to
confirm the pair is locked onto BOTTOM POLE (A). DO
NOT place more than one pair on each BOTTOM POLE (A)
at a time.
STEP 1
STEP 2
Place SHELF (D) on its side and slide (5)
BOTTOM POLES (A) through the holes in
SHELF (D). Make sure that SHELF (D) corner
cylinders are positioned over SLIP SLEEVES (E).
Stand the unit upright.
Note:
•
The level side of SHELF (D) is the TOP side
(the TRINITY logo on the corner cylinders
should be right-side up).
•
Use a rubber mallet, if needed, to secure
SHELVES (D).
D (1)