Trimteck Optimux HPP5500 Series, Руководство по эксплуатации продукта

Страница: 30 / 33

30 HPP5500
series
bIAS 25
BIAS value when valve position is at 25%
bIAS 75
BIAS value when valve position is at 75%
0Y 0d
Total used time duration. If a unit was used less than 1 minute, the
time will not accumulate.
FULL_OP
Time elapsed for valve to fully open
FULL_CL
Time elapsed for valve to fully close.
VM NOR
Type of valve stroke on LCD. (in percentage or in value)
Erro
Error code or warning message.
VALUE I Current I value
ABS
Absolute resistance value.
7. Error and Warning Code
7.1 Error code
Error Code Code Description and Cause Action
MT ERR L

Positioner is improperly installed.
 Positioner is not parallel to the
ground at 50% point. Lever is at
lower position than actual 50% point.

Re-install the positioner.
 Ensure the feedback lever does
not touch the lever stopper at 0%
and 100%.
MT ERR H
 Positioner is improperly installed.
 Positioner is not parallel to the
ground at 50% point. Lever is at
higher position than actual 50%
point.
 Re-install the positioner.
 Ensure the feedback leer does
not touch the lever stopper at 0%
and 100%.
CHK AIR
 Valve does not operate when
positioner receive “Full Open” signal
during the auto calibration.  Check supply pressure level.
RNG ERR
 Operating angle is too small due to
improper positioner installation.
 Adjust bracket so the positioner
can be mounted closer to
actuator.
C
Error of 10% or more persists more than 1
minute.
 No valve movement.
 High level of valve friction
 Changes in setting pressure of actuator.
 Perform BIAS calibration.
 Check setting pressure of actuator.