9
•
Place the knife lever in its top position.
•
Raise the front safety guard. Push the paper pile along the paper alignment from the front of the
system, and position against the back and left hand side gauges.
•
Push the back gauge crank towards the cutter to engage, turn the crank handle clockwise to
bring the back gauge towards the knife until the paper measurement is reached. With the help of the
fine adjustment ring, accurate measurement can easily be reached.
•
Release the back gauge crank, so that the unintentional movement of the back gauge can be
prevented.
•
Turn the spindle hand wheel clockwise to clamp the paper pile tight.
•
Lower the front safety guard, to reach the table.
•
Using both hands, lower the knife lever to cut the paper stack. When the cut is complete place the
lever into its top starting position, until this locks.
•
Turn the spindle hand wheel counter clockwise to release the paper pile. Lift the front safety guard,
and remove the paper pile from the cutter.
Ream Cutter Operation
(Spindle hand wheel systems):
(Flick action clamping system): Follow the above step one and two
•
Release the screw of the back gauge and adjust to the accurate measurement for cutting. Be sure to
tighten the screw once in its precise position.
•
Switch the lever of the flick action clamping system backwards (near to operator) when the clamping
device touches the paper pile, apply pressure to the handle until the paper pile is secured.
•
Close the hand guard firmly onto the table then the safety lock is released.
•
Using both hands, lower the knife lever to cut the paper stack. When the cut is complete place the
lever into its top starting position, until this locks.
•
Release the hand lever of the flick action clamping system. Lift the hand guard, and remove the paper
pile from the cutter.
Cutting Stick
If the last sheet of the paper pile does not cut through, even though the knife adjustment has already been
adjusted, the cutting stick should be changed or rotated.
The cutting stick can be used twice on each side, which means you can rotate each stick 8 times.
The cutting stick fits into the system table and can be lifted out using a screw driver. The pins in the base of the
systems table hold the cutting sticks, by securing the holes on each end of the stick onto the pins.
Please note. When the cutting stick is changed, the knife has to be readjusted. A knife which cuts too deeply
damages not only the cutting stick but also the knife too.
