14
14. If the blade and cutting stick does not
match, adjust the 3 (socket headless) screws
until they are 100% matching together.
15. Turn the select switch to the right and
press the 2 enable switches together to raise
the cutter and check the cutting function with
one sheet of paper. If the cutter does not cut
accurately, please follow the following steps.
10. Remove the protective pad and hold it
securely by the 2 cutter holders then reverse
the procedure to replace the new blade.
11. Assemble and turn the clamp hand wheel
downwards. The blade and the blade holder
should be close together.
13. Replace the left screw and close the safety
guard. Turn the power switch on and turn
the select switch to the left then press the 2
enable switches together. The cutter will lower.
Turn the select switch to the middle, open the
safety guard and fasten the right screw on the
right end of the blade holder.
12. Fasten the screw A tightly then remove
the 2 cutter holders and fasten the 2 B screws
tightly.
16. Using a 3mm hexagon wrench to adjust
the 3 (socket headless) screws on the top
of the carrier slightly and turn the fine
adjustment device of the cutter upwards/
downwards until the blade is in contact with
the cutting stick. Optimal adjustment is done
when the last sheet is cut accurately.
17. Place the metal cover onto the cutter
carrier then replace the clamp hand wheel and
fasten the screws. Finally fasten the screws on
the two ends of the metal cover.
