Trilithic EASyCAP C5020, Руководство по эксплуатации

Страница: 23 / 44

DRAFT
EASyCAP Encoder/Decoder - Manual
21
Select the Edit button to change the network settings, and then adjust the following settings:
LAN Port 1 (eth0)
The following settings can be adjusted for LAN Port 1 (eth0)
• DHCP - Select this checkbox to enable DHCP to automatically assign the IP
Address, Subnet, and Gateway of the Encoder/Decoder. When this check box is
selected these fields will be grayed out and cannot be manually adjusted.
• IP Address - When DHCP is not enabled, enter the IP Address of the Encoder/
Decoder into this field.
• Subnet - When DHCP is disabled, enter the Subnet Mask of the Encoder/Decoder
into this field.
• Gateway - When DHCP is disabled, enter the Gateway of the Encoder/Decoder
into this field.
LAN Port 2 (eth1)
The following settings can be adjusted for LAN Port 2 (eth1)
• Disabled - Select this checkbox to disable this port when only using one Ethernet
connection. When this check box is selected these fields will be set to “0.0.0.0”, be
grayed out, and cannot be manually adjusted.
• DHCP - Select this checkbox to enable DHCP to automatically assign the IP
Address, Subnet, and Gateway of the Encoder/Decoder. When this check box is
selected these fields will be grayed out and cannot be manually adjusted.
• IP Address - When DHCP is not enabled, enter the IP Address of the Encoder/
Decoder into this field.
• Subnet - When DHCP is not enabled, enter the Subnet Mask of the Encoder/
Decoder into this field.
• Gateway - When DHCP is not enabled, enter the Gateway of the Encoder/Decoder
into this field.
Attempting to assign both network interfaces to DHCP may
cause unreliable communication.