©1997-2017 Trikdis
5
www.trikdis.com
Ethernet communicator E10Tv2
1.5
Terminal block description
Contact
Description
+E
+12V power supply terminal
COM
Common ground terminal
T-CP
For connecting to the security control panel Tip terminal
R-CP
For connecting to the security control panel Ring terminal
T-TL
For connecting a telephone landline
R-TL
For connecting a telephone landline
IN1
1st input terminal for connection of external circuits (type NC)
COM
Common ground terminal
MCI
Provided for future use
1.6
Light indication
LED
Operation
Description
“Network” displays the status of
connection to the Internet
Green ON
Module is connected to the Internet
Yellow ON
TCP/IP session is open
“Data” displays data transfer
Green ON
Unsent messages present
Red ON
Messages cannot be sent
Green flashing
Messages are being received from the
control panel
“Power” displays power supply
status and the functioning of the
microprocessor
Green flashing
Power supply is sufficient
Yellow flashing
Power supply is not sufficient (≤11,5 V)
Installation process
1)
Configure communicator parameters before installation. For communicator configuration please refer to
3. Configuration and operation.
2)
Following provided schematics connect the control panel, sensors and output connections (refer to 5
Wiring).
3)
Connect LAN cable.
4)
Connect a DC power supply.
5)
Turn on the power supply.
6)
Perform system test (refer to 6 Performance test).
2.1
Program security control panel
Use programming manual of particular security control panel and set operation parameters of telephone
communicator as following:
1)
Enable the PSTN dialer of the panel.
2)
Select DTMF mode.
3)
Select Contact ID communication format.
4)
Enter a telephone number 1234 for dialing, if communicator is connected to the telephone landline (you
can use any number not shorter than 2-digits).
5)
Enter a 4-digit account number in the panel.
