Page 3
This manual contains the information required to install
and program the TRIGON Miniguard IID. If you are
using this manual to install this unit, it is very important
to read all the sections in order.
You should read these instructions before you begin
installation. This will insure that everything is done
efficiently.
Hookup Specifications
PRODUCT OVERVIEW
PRODUCT OVERVIEW
PRODUCT OVERVIEW
PRODUCT OVERVIEW
PRODUCT OVERVIEW
INTRODUCTION
INTRODUCTION
INTRODUCTION
INTRODUCTION
INTRODUCTION
TRIGON
MINIGUARD IID
CALL
A
Z
LETTER
SELECT
TRIGON ELECTRONICS
ORANGE CA.
4.2"
12"
Telephone Line-
Voice Gr ade 24 to 48V
22 AWG; Shielded
or Twisted,2 Conductor
Camera, Door or Gate
Secondary
Relay
Serial Printer
(18 AWG; Shielded, 3 Conductor)
Postal
Lock
Box
Primary
Output
Relay
Main Entrance
Power Cabling -
Shielded or Twisted,
2 Conductor,
18AWG up to 250'
16AWG up to 500'
Card Reader
(Interface Module Req'd)
18 AWG; Shielded,
4 to 6 Conductor
Alarm
Shunt
Relay
2.0"
Figure 1
The Trigon Miniguard IID is a handsfree, multi-number
Telephone Entry System for resident/visitor control.
Visitors contact the desired tenant by entering a simple
directory code gained from the built-in electronic
directory. Following a two way voice communication,
the resident then grants or denies access.
The Miniguard IID has a capacity of up to 400 telephone
numbers, up to 400 personal entry codes, up to 1600
data codes and is PBX Analog Port compatible. It is
constructed for rugged outdoor use. Its long-lasting
brushed-finish stainless steel housing complements its
thin design lines.
The Miniguard IID is available in surface mount,
weather mount, and flush mount. The weather mount
version is intended for use in open weather conditions
and comes standard with an LED lighted front panel.
The surface mount has a lower profile and is intended
for more protected locations. The flush mount utiizes
the wall mount front box and a flush mount back box
with a .75 inch trim ring.
The Miniguard IID is equipped with valuable features
and options that provide a wide range of guest and
resident control options—doors, gates, security lighting,
and more.
Two output relays are available to control a variety of
security devices. Records of all access activity are stored
in log memory, for downloading via direct connect or
modem.
Note: Printer log output is disabled in order to support
TriCom-Pro modem interface.
The Miniguard IID supports Trigon’s TriCom-Pro
protocol. TriCom-Pro is Trigon’s universal database
handler and communications package designed to run
on most standard IBM compatable PCs using Windows
98 or greater.
This software link is achieved via a 2400 baud, full
duplex modem, or direct 3-wire RS-232 connection
using a null modem cable.
The Miniguard IID’s data base can also be edited via
the display and keypad on the face of the unit.
If you are using this manual as a programming guide
after the initial installation, you may find the TABLE
OF CONTENTS useful in locating the particular
programming procedure you need.
Содержание MiniGuard IID Series
Страница 17: ...Page 17...
