CONNECTION OF HOSEPIPES TO THE PUMP
1.
Skimmer Circuit:
Connecting the skimmer to the connection in front of
the pump.
2.
Vacuum hosepipe:
Joining the upper connection of the pump to the
connection designated ‘PUMP’ on the valve.
3.
Return hosepipe:
Joining the valve connection designated ‘RETURN’ ’ a
la connection to the inlet connector of the pool. Secure all the connections
with metal clips.
4.
Wastewater hosepipe:
Joining ‘COUNTERWASH’ to the hosepipe or to
the lawn. The connection is made with the hosepipe of the pool and
specific metal clips!
STARTING UP THE FILTER/PUMP
1. Before starting up the monoblock, make sure that it is situated outside the
pool and at a lower level than the water level in the pool. The flexible
connections must be well connected and fixed.
2. The pool must be full of water up to the mid height of the skimmer. The water
must circulate to the pump
3. Now purge the air from the monoblock. If some exists, open slightly the top of
the pre-filter of the pump until the water enters the pre-filter.
4. Place the valve selector in position COUNTERWASH. Only this way can the
pump be started. Begin a cycle of COUNTERWASH of 2 to 3 minutes. Then,
switch off the pump and put it in CLEAR position. The CLEAR cycle lasts +/- 30
seconds. Switch off the pump again and putt he selector valve in FILTRATION
position. Evacuate the water from COUNTERWASH & CLEAR to the hosepipe
or onto the lawn. We recommend doing 2 filtration cycles of 4 to 5 hours a day.
Содержание J-PSC064
Страница 1: ......
