TriCom TCR-L-50, Руководство оператора

Страница: 13 / 35

9
2.0 OPERATION
2.1 GENERAL INFORMATION
The TCR-U/L-50 can be used for operation once it has been installed as described in Section 3.
2.2 CONTROLS
The TCR-U/L-50 has a menu driven display controlled with three buttons as shown in Table 2-1:
Table 2-1. Front Panel Controls
CONTROLS TYPE FUNCTION
MODE/ENT Pushbutton Switch Select MODE
"Affirmative" in Menu Function
MENU Pushbutton Switch
Enter Menu Function
Advance in Menu Function
PWR/ESC Pushbutton Switch Power On, Power Off
Select Power Level
"Negative" in Menu Function
2.3 POWER ON, INITIALIZATION, AND SET UP
Pressing the front panel PWR pushbutton initiates a Power On Self Test (POST) process after
which the amplifier enters the Home Display. The TCR-U/L-50 has an auto-start configuration
which is enabled as a factory default.
From the Home Display, the user can cycle through modes with momentary presses of the front
panel MODE pushbutton. Modes cycle in the order depicted in Section 1.3.1.
Note: There is a three second delay in setting mode during which time the OLED will display
“SETTING MODE” followed by “MODE SET”.
Power levels are set using the front panel PWR pushbutton. A single press of the PWR
pushbutton from the Home Display will cycle through the available power levels: 10, 15, 20, 35,
and 50W (UHF Narrowband modes) and 10, 25, and 50W (WB and TW modes). The default
selection is 50W for all modes. Note, L-Band is limited to 25W output power.
WARNING
ELECTROMAGNETIC RADIATION FROM THE ANTENNA CAN DAMAGE EYES
AND OTHER BODY TISSUE WHEN THE SYSTEM IS TRANSMITTING. DO NOT
STAND DIRECTLY IN FRONT OF THE ANTENNA OR IN CLOSE PROXIMITY TO
THE SIDES OR BACK OF THE ANTENNA WHEN TRANSMITTING.