DI Out:
The main DI out on the Trilobite is a high quality, low noise DI that is great for both live and studio applications.
This DI features a PRE/POST button as well as a GROUND LIFT button. The PRE/POST button allows you to route
either a completely PRE-TRILOBITE signal out of the DI or a POST-TRILOBITE signal out of the DI. When you are
in the PRE setting the signal coming out of the DI is not affected by the gain, EQ or either FX loops. When the
PRE/POST button is out in you are in the PRE setting and when it is pressed in you are in the POST setting. The
POST setting will allow all the Gain, EQ and FX loop settings to route out the DI.
DI AUX Out:
There is a second DI out on the Trilobite that is labeled AUX Out. This second DI is set to POST and will pass the
full signal of the Trilobite pedal. This is great for sending a second DI signal to a monitor desk or directly to your
on stage In-Ear monitor rig allowing you to have a great tone for your In-Ear mix that you could blend in with the
House mix that is sent to you from the engineer… more on that later. A second use for this AUX Out would be to
have 2 channels sent to the mixing console, one clean and one dirty. In this case you would use the main DI output
set to PRE and the Aux DI would be your POST signal allowing the engineer to have a completely dry bass signal
to mix with the signal coming from the Trilobite.
1/8” AUX In and 1/8” HP Out:
Next to the power input on the back of the Trilobite you will find an 1/8” Aux in out and and 1/8” Headphone output
that is great for silent practicing or to monitor yourself on a gig by plugging you in ear monitors directly into the
Trilobite. Both the AUX in and HP out are true stereo and make a great practice setup for silent practicing between
gigs or at home. Note that the input gain for the Aux in is set so you will use your device like your computer or
MP3 player to control the volume of the source. The Master volume on the Trilobite will act as an outpost value
for your bass so that you can balance that with the signal of the AUX in.
Amp Out:
The Amp out is used to send the signal from the Trilobite to your bass amplifier, power amp or powered speaker.
Tuner Out:
The Tuner out is a great place to connect your tuner to keep it out of your signal path and to allow for you to silent
tune on the gig via the MUTE foot-switch.
A/B Foot-switch:
The far left foot-switch is the A/B selector foot-switch. This allows you to pick which preamp section, A or B, you
want to be active. Note that the Trilobite is a switcher and not a mixer, only one preamp section may be used at
once.
FX Foot-switch:
The middle foot-switch is the FX foot-switch. This allows you to turn on and off the signal to the FX loop. Note that
when the FX loop return has a cable plugged in that the side chain volume is engaged and is active even when the
FX foot-switch is turned off.
MUTE Foot-switch:
The far right foot-switch the MUTE foot-switch. This is a global mute and will mute all outputs except for the
Tuner Out allowing you to tune silently on stage.
Содержание Trilobite
Страница 1: ...Trilobite Operation Manual ...
