Trick-tools Hougen-Ogura PUNCH PRO 75004PR, Руководство оператора

Страница: 5 / 16

5
Although the foot switch is guarded against inadvertent
operation, it is best to position the foot pedal away from
normal standing position. Place it in a position that
requires deliberate effort to reach and activate the switch.
The trigger switch should be locked on only when ready
to punch. Release the trigger switch immediately after
punching to prevent operation by inadvertent actuation
of the foot switch.
FOOT SWITCH
The Hole locator Gauge can be set to hold the Hole
Punches at a constant distance from the edge of the
workpiece. The gauge is held in place by one or two socket
head caps screws. Before making any adjustment,
first, unplug the power cord. To adjust the position of the
gauge, loosen the cap screw(s), tap the gauge into the
desired position and retighten the cap screw(s).
HOLE LOCATOR GAUGE ADJUSTMENT
All models can be used with an accessory work stand for
bench or table mounting of the Hole Puncher. The stand
is standard with all models. To install the stand, first
unplug the power cord., then mount the unit to the stand
with the supplied hardware.
When using the stand, periodically check to make sure
that the punched material (slugs) are not stacking up
between the exit hole in the "C"-frame and the stand.
Keep this area clear of accumulated slugs.
USING THE WORK STAND
TRIGGER SWITCH
SLIDE STOPPER
Pull the trigger switch for punching operation. Make
sure that the switch is fully depressed. DO NOT ride
the switch as this will harm the motor.
The lock button is used to lock the trigger switch “on”
when using the foot switch. Pull the trigger switch and
push in the lock button. To unloc, push in the lock
button again.
Punching up to 40mm depth, from the edge of material, can be done using the slide stopper.
CAUTION
Before attaching or removing slide stopper, ensure that
the machine is disconnected from its power source to
prevent accidental operation and personal injury.
1. Loosen the set bolt and nut to remove the Die.
2. Remove the bolt and washer fixing the slide stopper.
3. Remove the slide stopper by pulling it to the upper side
of the C frame.
4. Insert the slide stopper for maximum depth from the
bottom side of the C frame.
5. Fix the slide stopper with the bolt and washer removed
in procedure #2 above.
6. Install the die with the set bolt and nut removed in
procedure #1 above.