19
If, at the end of a programme, there is water in
the tub, (the light
still on)
to empty out
the
water follow the following instructions:
To empty out the water proceed as follows:
1. turn the programme selector dial to «
O
»
2. select the
Drain
» or «
Spin
» programme
3. reduce the spin speed, if needed, by
pressing button
4. press button
5. at the end of the programme, the display
shows «
0
», the light
goes off. It will be
possible now to open the door.
9
8
2
9
Turn the programme selector dial to «
O
» to
switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash,
close the water tap.
Leave the door open to prevent the formation
of mildew and unpleasant smells.
Operating sequence - Drying only
The max load to dry in your washer -dryer is 3
kg for cotton and 2 kg for synthetics.
The water tap must be open and the drain
hose must be positioned in the sink or
connected to the drain pipe
.
1. Load the laundry.
2. Turn the selector dial to «
Cottons
» or
«
Synthetics»
programme in the «Drying»
section.
3. If you wish to select the automatic drying
(
Cupboard dry
or
Iron dry)
, press button
until the light corresponding to the
desired dryness degree for synthetics or
cotton illuminates.
4. If you wish to select a
timed drying
, press
button
until the time you want appears
on the display (see the drying pro-
grammes).
Note!
The drying time will automatically increase by
up to 2 minutes. This is quite normal.
4
3
5. Press button
to start the programme.
After the programme has started, the time
remaining is updated every minute.
6. At the end of the programme, the buzzer
sounds. A flashing zero «
0
» appears on
the display.
The last 10 minutes of the drying cycle cor-
respond to an anti-crease phase. During
this time the door is locked and the display
keeps showing the flashing zero
«
0
».
Note!
If you wish to open the door before or
during the anti-crease phase or to interrupt
it, press any button or turn the programme
selector dial to any programme position
(except «
O
»), the door can be immediately
opened.
7. Turn the selector dial to the «
O
» position to
switch the machine off. Remove the laun-
dry.
8
132966550.qxd 28/02/2008 13.56 Pagina 19
