18
IMPORTANT!
• If the programme has already started, the
selected delay can be modified only after you
have turned the programme selector dial to
the «
O
» position and after you have selected
the programme again.
• The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washer dryer to PAUSE by
pressing button
. After you have closed
the door, press the same button again.
Note!
The Delay Start cannot be selected with
«Drain» programme.
Start the programme by pressing button
To start the selected programme, press this
button; the corresponding green pilot light
stops flashing. The appliance starts operating
and the door is locked.
To interrupt a programme which is running,
press button
: the green pilot light starts to
flash.
To restart the programme from the point at
which it was interrupted,
press
button
again
.
If you have chosen a delayed start, the
machine will begin the countdown.
IMPORTANT!
If an option which is not compatible with the set
wash programme is selected, the message
Err
is displayed for a few seconds and the
red
light
of this button flashes 3 times.
Altering an option or a running programme
It is possible to change some options before
the programme carries it out.
Before you make any change, you must pause
the machine by pressing button
.
8
8
8
8
8
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «
O
» and then to the new
programme position. Start the new programme
by pressing button
again.
The washing water in the tub will not empty
out.
Interrupting a programme
Press button
to interrupt a programme
which is running, the corresponding light starts
to flash. Press this button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «
O
» to cancel a
programme which is running. You can now
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing
button .
If the light
goes off, the door can be
opened. If this light doesn’t go off and the door
remains locked, this means that the machine is
already heating, that the water level is above
the bottom edge of the door.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «
O
». After a few
minutes it will be possible to open the door
(Pay attention to the water level and
temperature!
).
After this procedure, it will be necessary to set
the programme and the options again and then
to press button
.
At the end of the programme
The washer-dryer stops automatically. Some
acoustic signals sound and on the display will
appear a flashing «
0
». The button
light
and the light
go off. The door
can be opened.
9
8
8
9
8
8
8
132966550.qxd 28/02/2008 13.56 Pagina 18
