TriBrer Lemon 5, Руководство пользователя

Страница: 30 / 32

Troubleshooting
28
Phenomenon Reason Solution
Fiber Core axial misalignment
V-groove or optical fiber presser is dusty Clean the V-groove and optical fiber presser
Fiber Core angle error
V-groove or optical fiber presser is dusty Clean the V-groove and optical fiber presser
Fiber core step
Fiber core bending
Poor quality of fiber end face
V-groove or optical fiber presser is dusty
Poor quality of fiber end face
Low prefuse power or short prefuse time
Check the fiber cleaver
Clean the V-groove and optical fiber presser
Check the fiber cleaver
Increase prefuse power and/or prefuse time
Mode field diameter mismatch
Low splice power Increase the splice power and/or splice time
Poor quality of fiber end face
Dust still exists after cleaning the fiber or discharge
Poor quality of fiber end face
Low prefuse power or short prefuse time
Small overlap
High prefuse power or long prefuse time
Large overlap or low prefuse power
Inappropriate splicing power
Some inappropriate splicing parameters
Some inappropriate splicing parameters
Dust
Bubble
Fiber separation
Too fine
Too rough
Thin line
Check the fiber cleaver
Clean the fiber thoroughly or increase the cleaning and discharge time
Check the fiber cleaver
Increase the prefuse power and/or prefuse time
Increase overlap
Decrease prefuse power and/or prefuse time
Decrease overlap or increase prefuse power
Do ARC calibration
Adjust prefuse power, prefuse time or overlap
Adjust prefuse power, prefuse time or overlap