- 13 -
CCS-2 2001
5
P
rogramming
5.1 P
rePar ation
•
Test the software versions of the head-end station and the cassette and up-
date them if necessary. The current software versions can be found on the
website "
www.triax.com
".
• Connect the test receiver to the HF output or the test output of the head-end
station.
• Set the output channel / output frequency of the
cassette (page 24) and adjust
the TV test receiver to this channel / frequency.
•
Switch on the modulator if necessary (page 17).
5.2 n
otes
on
Progr a mming
via
the
Control
soft ware
It is much more convenient to programme the cassette via the control software
CCRS 1000.
—> Therefore please read the operating instructions for the software
CCRS 1000
, you will find
on the CD added.
A quick setup of the cassette and filter settings as well as remapping a service
ID (SID) is only possible via CCRS 1000 (from version 43 on).
—> Therefore observe chapter 5.6, page 38
5.3 n
otes
on
level
set ting
In order to prevent interference within the head-end station and the cable sys-
tem, the output level of the cassette must be decreased by 8 dB compared to
analogue cassettes.
• Measure the output levels of the other cassettes and tune them to a uniform
output level using the appropriate level controls or software dependent on
the head-end station used. Please regard the assembly instructions of the
respective head-end station.
