L35 Series Install Guide
Page 19 of 20
TRIATEK® Lighting • 1025 Cobb Place Blvd. Suite 100 Kennesaw, GA 30144 • 800-241-9173 • www.triateklighting.com
11/30/2004
Due to continuous product improvement, TRIATEK Lighting reserves the right to change product specifi cations without notice.
6. Remount the LMB.
7. Plug the ribbon cable into its socket on the LMB.
Figure 31 demonstrates the
location and labeling of this socket. The socket is labeled ‘LCD DISPLAY’ or ‘DDN’.
8. Connect the power wires for the DDN to the LMB.
Figure 32 gives the loca-
tion for power source for the DDN module. The power terminal on the LMB and
DDN has “P” and “G” labels for hot and ground connections respectively. Connect
the black wire to “G” on the LMB and the red wire to “P” on the LMB.
9. Run both wires together between the LMB and the hinged backplate and
then pull the wires between the two bottom screws of the LMB.
Example run
is shown in Figure 32. If power is run to the DDN across the side of the backplate,
when the backplate is closed, the wires will get pinched.
10. Open the hinged plate and pull the wires to the DDN module.
Terminate the
wires at the provided power terminal block. See Figure 33.
11. Reconnect power to the LMB.
Refer to Figure 4 on page 7 for power termina-
tion location. Figure 32 also gives the location.
Figure 30
Folding the DDN Ribbon Cable with Backplate
Closed
Figure 31
DDN Ribbon Cable
Connection on LMB
Label of DDN ribbon cable
socket on the LMB.
Expanded view of ribbon
cable plugged into socket.
