L35 Series Install Guide
Page 11 of 20
TRIATEK® Lighting • 1025 Cobb Place Blvd. Suite 100 Kennesaw, GA 30144 • 800-241-9173 • www.triateklighting.com
11/30/2004
Due to continuous product improvement, TRIATEK Lighting reserves the right to change product specifi cations without notice.
Connecting TRIATEK Lighting LS5 Photocell Inputs
The L35 Series Controller comes with one input for the LS5 Series Photocells. Each
LS5 photocell ships with one pigtail wiring harness. The contents as shipped are
shown in Figure 12. The LS5 photocells have three (3) wires each. Figure 13 gives a
wiring schematic for an example LS5 photocell.
The photocell is powered by 5V from the L35 Series Controller. The power circuit
includes the Red (5V hot) and the Black (ground) wires. The yellow wire carries the
0-5V input signal from the photocell which is then scaled to a value used by the
LPPK Software. Instructions for installing the LS5 Photocell follow.
1. After installing TRIATEK Lighting’s LS5 Photocell, splice extension wires to
photocell wires.
If possible use the same color wires provided with the photocell.
A maximum of 500 feet of wire total is allowed, measured from the photocell to the
LMB socket. Use 18-22AWG wire.
2. Remove power from LMB.
3. Locate the photocell input socket on the LMB.
See Figure 14 for its location
and labeling.
4. Splice wires to the pigtail provided with the photocell.
Pigtail wire colors
match those provided with the photocell. Splice wires to match the color coding.
5. Plug the connector onto the socket on the LMB.
The pigtail connector is
keyed to fi t in one orientation on the LMB socket. Figures 15 shows the proper
orientation to install the connector.
6. Reconnect power to the LMB.
Figure 15
Figure 12
LS5 Pigtail Wiring Harness
LS5A Indoor Atrium Sensor
Figure 14
Location of LS5 Pho-
tocell Input Socket on
L35 Series LMB
Red
Yellow
Black
5V
IN
G
Connector
LS5 Photocell
Figure 13
